Waterat Sailing Equipment Mast Spec
Two versions of the specification diagram are available. You can view it as a .gif file, or in a .pdf version. HOWEVER, READ THESE SPECIFICATION UPDATES FIRST! They are not reflected on the diagrams yet!
Specification Updates
- shroud length was changed to 16'4" (Note: this is two inches shorter than the old spec, and what you get if you cut off the old swaged-on fittings right next to the fitting, and swage on new ones)
- spinn halyard at new maximum height
- pole lift at maximum height under jib halyard
- pole launcher fitting at about 900mm
- jib halyard: 1/8" vectran
- trap wires 7/64" or 1/8" spectra, or 1/8" vectran
- pole lift 7/64" spectra
OK, now you can look at the Waterat mast spec diagram. The PDF version is much easier to read
